![]() ![]() Step 2: Enter a new four-digit code on the keypad. When the LED light is lit, this indicates your 30-second window to complete the setup process. Step 1: Locate and press the LEARN button on the motor housing. With the memory wiped and the remote control connected/reconnected, follow these steps to program your Chamberlain keypad to open and close the garage door using the keypad: Repeat this process until the garage door light bulb blinks. NOTE: Do not press the button after the lightbulb blinks! The light on the opener will flash.Press the remote button again to activate the door. Press and release the remote control button again. Wait for the remote control LED to light and stay on. Locate the LEARN button again on the motor housing press and release it. Press and release the remote control button within 30 seconds of releasing the LEARN button. Once you have pressed the button on the remote control the correct number of times, press any other button on the remote once.The LED light on the remote will turn off. Press and RELEASE the LEARN button on the garage door opener. The LEARN LED light will turn on. Press and RELEASE the button on the remote control the following number of times for your model:1 = Security+ 2.0 (Yellow)2 = 315 MHz Security+ (Purple)3 = 390 MHz Security+ (Red/Orange)4 = 390 MHz Billion Code (Green) On some remote controls, an LED light will light up once you have pressed the reset button to indicate you can proceed with the following steps: For older models: Do this by sliding the metal clip off the remote and then find the reset button on the front, side, or back center. To reconnect your Chamberlain remote control, locate the reset button on the remote. ![]() With the memory wiped, you will need to connect a new remote control if you lost the original or reconnect the existing remote control if you reset it for another reason.
0 Comments
Leave a Reply. |